Use the Messaging dialog to define the messages should be sent when an alarm occurs.
In this dialog, you set up the camera to only send an email when the video motion sensor detects a movement, but not when the PIR sensor reports an event, for example. See also: Example for Using Event Control.
|Note:||Click on the More button to display all options of the dialog.|
The messaging dead time defines a period of time (0 - 3600 sec) after an alarm message during which no further alarm messages are triggered.
Highlight the events that are supposed to trigger a message. The factory setting All triggers the messages defined below for all events.
|Note:||This selection does not affect image storage in the camera's internal storage or on a file server.|
|Sound on Event (SD)||In case of an alarm, the camera can play an audio file.
Open the Manage Voice Messages dialog in order to create or delete your own voice messages or to select one of the pre-recorded audio files.
|E-mail Action (EM)||In case of an alarm, the camera can send notifications via email.
Create at least one profile in the E-Mail Profiles dialog so you can select it here.
Select event image to attach the event image to the email. Selecting profile (you only will be able to do so when you have clicked on More before) will use the settings defined in the email profile.
|Second E-mail (EM2)||Select a second email profile to send the notification to.|
|ISDN Call Action (CL):||In case of an alarm, the camera can send voice messages via telephone.
You can select any profile as a destination that you have defined in the ISDN Dial-Out Profiles dialog.
To create a profile for the ISDN voice notification, proceed as follows:
|IP Notify (IP)||
In case of an alarm, the camera can send a network message to another computer's TCP port.
To enable sending network messages, do the following:
|See also:||Example for Using Event Control|
Click on the Set button to activate your settings and to save them until the camera is rebooted.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.